This panel cutter is used to make a Convex cut on 5/8 inch panels alone, or 3/4 inch panels when combined with our DC2300 or DC2325 undercutters. This industrial quality shaper cutter is manufactured with 3 mm thick C-2 carbide. 5,000- 10,000 RPM.
- A = 4-5/8 Inch Cutter Diameter
- B = 5/8 Inch Cutting Length
- w = 1-1/2 Inch Cutting Width
- 3/4 Inch Bore Diameter
- Manufactured with 3mm thick C-2 Carbide
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
