Sheartak Spiral Cutterhead for Griggio PS 520 Rapida Planer with132 Carbide Inserts

* Each cutter sits at a slight angle to the feeding and cuts in a staggered way.  This combined shear and staggered cut eliminate tear-out, makes the quality cut and leaves a smooth finish on any board.

* Noise is hugely reduced as each cutter gradually removes materials at only a short portion of the length.

* The 15x15x2.5mm inserts are made of sintered tungsten carbide which is much harder than high-speed steel. Each insert has four edges.

* The carbide cutterheads are precision ground to a very high accuracy standard and are interchangeable. Loosen the screw, rotate 90° for a new edge, and tighten the inserts. Change-over takes only a few minutes.

* Dust extraction is more straightforward. No chip clog at dust collection.

* Low cost to use. Spiral cutterheads reduce 3/4 of your sanding work and don't require sharpening. Your investment will be paid back in no time.

 Spiral Cutterhead Kit includes:

* High tensile strength alloy steel cutter block.

* 132 carbide inserts installed.

* 5 extra carbide inserts.

* 5 extra screws.

* 1 Wrench