Spiral Cutterhead for Lurem C510B 1975 planer is equipped with 176 carbide inserts on 8 spirals. Each carbide insert has 4 indexable edges. The carbide inserts are slightly angled to the board feeding, which generates a shear cut, eliminates tear-out, and leaves a glossy surface finish on softwood, hardwood, and man-made board. It dramatically reduces operation noise. Simply rotate the edge 90 degrees if it is dull or chipped and you will have a new sharp edge. Discard the inexpensive carbide inserts only when all four edges are affected. No need to sharpen the inserts. This greatly reduces downtime. Sheartak spiral cutter heads reduce three-quarters of your sanding work and consume less power. Spiral cutter heads remove short chips in a staggered way and avoid dust clog at the hood port. Dust extraction is significantly improved. Sheartak spiral cutter heads can pay back your initial investment in no time.
Kit includes:
* High tensile strength alloy steel cutter block.
* 176 carbide inserts installed.
* 5 extra carbide inserts.
* 5 extra screws.
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
