Spiral Cutter Head for FELDER  16" Jointer Planer Combination BF 7-41 with 102 Carbide Cutters

Upgrade your machine for the following benefits.

* Smoother Finish with no tear-out. Each knife sits at a slight angle and produces a shear-cut. Spiral cutter head planes board in a staggered way which is much better than a single straight cut. The combined shear and staggered cut eliminates tear-out and leaves a glossy surface finish on even highly figured hardwood.

*  Noise is hugely reduced as the spiral cutter head allows a few knives to cut in a staggered way.

* More than 10 times the life use of high-speed steel. The 15x15x2.5mm inserts are made of sintered tungsten carbide which is much harder than high-speed steel. Each insert has four edges.

* Easy to change. The knives are precision ground to a tolerance of +/-0.0004" or +/-0.01mm and are interchangeable. Loosen the screw, rotate 90° for a new edge, and tighten the insert in minutes.

* Dust extraction is easier. The spiral cutter head produces thinner and shorter chips.

* Low cost to use. Spiral cutter heads produce a smoother finish, reduce or eliminate sanding work, and don't require sharpening, your product will pay for itself in a very short time.

Standard Kit Includes:

* High tensile alloy steel cutter block

* 102 Carbide Inserts Installed

* 5 Additional Carbide Inserts

* 5 Additional screws

* 1 Torx head T-type key