Husqvarna HiPERFLOOR GM 3000 Concrete Hole Filler

Use GM 3000 surface preparation and re-grouting solution to fill small pin holes in concrete floors before polishing the surface.

Features

• Latex-based bonding additive for concrete pore filling and re-grouting applications
• Fill and patch small holes and air pockets in concrete floors before polishing

Husqvarna GM3000 Benefits

• Fills small pin holes in concrete
• Enhances the final clarity and shine of polished concrete floors
• Improves the overall cleanliness of the finished concrete floor by eliminating tiny holes and voids where bacteria can grow
• Eco-friendly
• VOC compliant
• Ready to use - no mixing or dilution required

GM3000 Application

A pump sprayer and fine bristled broom are required for application

• Step 1 - Spray a small coat of water onto the floor (do NOT allow water to pool or form puddles) - water helps facilitate product absorption into the concrete
• Step 2 - While the floor is damp, spray a liberal coat of GM3000 onto the floor roughly 10 - 15 ft. ahead of the concrete grinder
• Step 3 - Brush the damp concrete floor with a bristled broom to remove any dust or debris from the pin holes and pores
• Step 4 - Grind the wet area using 120 grit diamond pads; GM3000 will mix with dust from the floor to create a slurry - this slurry will work its way into the small pin holes in the floor
• Step 5 - Sweep the concrete floor with the fine bristled broom to remove excess slurry from the floor
• Step 6 - Apply concrete densifier and distribute evenly across the floor using a micro-fiber mop; let densifier sit for 4-8 hours

Approximate Coverage

• 5 gallons provides 1,000 - 1,500 sq. ft. of coverage (about 250 sq. ft. per gallon), depending on the porosity of the concrete

GM3000 Grouting System Shelf Life

• Unopened containers have a 3 year shelf life from the date of manufacture
• GM3000 should be stored at room temperature (about 70°F)
• Once opened, do not allow any dirt, water, or other contaminates to accumulate inside the bottle

How to Clean Application Equipment

• Use water to clean application gear if GM3000 has not already dried
• Use xylene or other approved solvent to clean equipment if GM3000 has already dried